Physical AI News (Japan)

Physical AI, robotics and compute — reported from Japan.

日本語
· Product launches· 日本語で読む

Kawasaki Heavy Industries introduces power regeneration for industrial robots, cutting power use 30%-40% during continuous operation

Kawasaki Heavy Industries introduced a feature that recovers energy generated when industrial robots decelerate. A power regeneration board in the F0x controller returns the recovered electricity to the factory’s power system. The company says the feature cuts power consumption 30%-40% during continuous operation.

What happened

On November 13, 2026, Kawasaki Heavy Industries released a video introducing a power regeneration feature that recovers energy generated when industrial robots decelerate. According to Robosta, the video says a power regeneration board in the company’s F0x controller recovers electricity and cuts power consumption 30%-40% during continuous operation.

Why it matters

Kawasaki Heavy Industries says the F0x controller recovers energy when the robot decelerates and returns it to the factory’s power system, reducing power consumption across the facility rather than just at the robot. The company puts the reduction at 30%-40% during continuous operation, but the article about the video does not specify the calculation conditions. The effect at an individual factory therefore needs to be assessed based on operating conditions and the scope of measurement.

Analysis

The key point of the feature described in the video report is that electricity recovered by the robot is not used only to power that machine’s operation: it is converted from direct current to alternating current and returned to the factory’s power system. According to the article, deceleration energy was previously converted into heat using a regenerative resistor. The effect should therefore be assessed not only in terms of the robot’s power consumption but also by including the reuse of recovered electricity within the factory. However, the 30%-40% figure is an explanation in the video about continuous operation; the article does not state the comparison conditions or scope of measurement. The figure cannot be applied as is to other operating conditions. Power regeneration in industrial robots addresses an operational challenge distinct from motion control or avoiding work failures. NTT develops AI technology for loading cargo, which we covered, is a technology aimed at avoiding failures by predicting changes in the state of an object after movement. The feature in this report reuses energy generated during deceleration as electricity. The two should not be treated as the same technology, but as addressing different challenges related to robot operations. The article also does not establish a connection between this power regeneration feature and the data collection, training and real-world evaluation discussed in Memories.ai reportedly builds a standardized pipeline for first-person video data for robots. When considering equipment installation, the focus will be on assessing not just the reduction rate during continuous operation but also operating patterns, robot models and connection requirements for the factory’s power system. The article says the F0x controller is compatible with a wide range of Kawasaki Heavy Industries robots, but does not specify the models covered or the conditions used to calculate the 30%-40% figure. Points to verify include the measurement conditions for the reduction rate, the models and operating conditions covered, and the method for assessing the entire factory, including recovered electricity. Until these are provided, the stated reduction rate is not a basis for estimating the effect on an individual production line.

Sources

Translated from the Japanese original: /news/kawasakijuukou-sangyouyou-robotto-no-denryoku-kaisei-kinou-w-f49245. The Japanese version is authoritative if they differ.