モジュール式パイプクライマー
Modular Pipe Climber
120度配置の3つの独立トラックと受動ばねで管内壁に接触し、垂直登攀や曲がり管を移動できる配管検査ロボットを設計・試作した。
著者: Rama Vadapalli, Kartik Suryavanshi, Ruchita Vucha, Abhishek Sarkar, K Madhava Krishna
分類: cs.RO
原文アブストラクト
This paper discusses the design and implementation of the Modular Pipe Climber inside ASTM D1785 - 15e1 standard pipes [1]. The robot has three tracks which operate independently and are mounted on three modules which are oriented at 120{\deg} to each other. The tracks provide for greater surface traction compared to wheels [2]. The tracks are pushed onto the inner wall of the pipe by passive springs which help in maintaining the contact with the pipe during vertical climb and while turning in bends. The modules have the provision to compress asymmetrically, which helps the robot to take turns in bends in all directions. The motor torque required by the robot and the desired spring stiffness are calculated at quasistatic and static equilibriums when the pipe climber is in a vertical climb. The springs were further simulated and analyzed in ADAMS MSC. The prototype built based on these obtained values was experimented on, in complex pipe networks. Differential speed is employed when turning in bends to improve the efficiency and reduce the stresses experienced by the robot.
関連論文
- 配管内を滑らず走行する3出力差動式クローラロボット管内移動ロボット
- 多出力差動機構を備えたモジュール式パイプクライマーIIIの設計と解析管内移動ロボット
- 配管内を自在に移動する全方向3モジュールロボットの設計とシミュレーション管内移動ロボット
- 全方向移動可能な3モジュール管内ロボット管内移動ロボット
