キリガミカットとアクティブラーニングによる完全ソフト展開構造の迅速設計
Rapid design of fully soft deployable structures via kirigami cuts and active learning
キリガミカットと二層のひずみミスマッチを組み合わせた平面作製法と、オートエンコーダとアクティブラーニングで逆設計を効率化する枠組みを提案し、多様な3D形状の生成を実証した。
著者: Leixin Ma, Mrunmayi Mungekar, Vwani Roychowdhury, M. Khalid Jawed
分類: cond-mat.soft, cs.RO
原文アブストラクト
Soft deployable structures - unlike conventional piecewise rigid deployables based on hinges and springs - can assume intricate 3-D shapes, thereby enabling transformative technologies in soft robotics, shape-morphing architecture, and pop-up manufacturing. Their virtually infinite degrees of freedom allow precise control over the final shape. The same enabling high dimensionality, however, poses a challenge for solving the inverse design problem involving this class of structures: to achieve desired 3D structures it typically requires manufacturing technologies with extensive local actuation and control during fabrication, and a trial and error search over a large design space. We address both of these shortcomings by first developing a simplified planar fabrication approach that combines two ingredients: strain mismatch between two layers of a composite shell and kirigami cuts that relieves localized stress. In principle, it is possible to generate targeted 3-D shapes by designing the appropriate kirigami cuts and selecting the right amount of prestretch, thereby eliminating the need for local control. Second, we formulate a data-driven physics-guided framework that reduces the dimensionality of the inverse design problem using autoencoders and efficiently searches through the ``latent" parameter space in an active learning approach. We demonstrate the effectiveness of the rapid design procedure via a range of target shapes, such as peanuts, pringles, flowers, and pyramids. Tabletop experiments are conducted to fabricate the target shapes. Experimental results and numerical predictions from our framework are found to be in good agreement.
