軟質熱可塑性エラストマー膜のペレット式3Dプリンティングによるソフトロボティクス応用
Pellet-based 3D Printing of Soft Thermoplastic Elastomeric Membranes for Soft Robotic Applications
軟質熱可塑性エラストマーをペレット式3Dプリントし、伸縮性の高い薄膜や屈曲アクチュエータ、触覚センサ付き吸盤を試作した研究。
著者: Nick Willemstein, Mohammad Ebrahim Imanian, Herman van der Kooij, Ali Sadeghi
分類: cs.RO
原文アブストラクト
Additive Manufacturing (AM) is a promising solution for handling the complexity of fabricating soft robots. However, the AM of hyperelastic materials is still challenging with a limited material range. Within this work, pellet-based 3D printing of very soft thermoplastic elastomers (TPEs) was explored (down to Shore Hardness 00-30). Our results show that TPEs can have similar engineering stress and maximum elongation as Ecoflex OO-10. In addition, we 3D-printed airtight thin membranes (0.2-1.2 mm), which could inflate up to a stretch of 1320%. Combining the membrane's large expansion and softness with the 3D printing of hollow structures simplified the design of a bending actuator that can bend 180 degrees and reach a blocked force of 238 times its weight. In addition, by 3D printing TPE pellets and rigid filaments, the soft membrane could grasp objects by enveloping an object or as a sensorized sucker, which relied on the TPE's softness to conform to the object or act as a seal. In addition, the membrane of the sucker acted as a tactile sensor to detect an object before adhesion. These results suggest the feasibility of AM of soft robots using soft TPEs and membranes as a promising class of materials and sensorized actuators, respectively.
関連論文
- 課題から解決へ:生体模倣3Dプリンティングによる軟質・硬質材料の接合ソフトロボティクス/3Dプリンティング
- 視覚ベースのFDM印刷による気密性ソフトアクチュエータの作製ソフトロボティクス/3Dプリンティング
- 傾斜多孔質を持つ軟質流体アクチュエータの直接3Dプリンティングソフトロボティクス/3Dプリンティング
