モデルロケットの推力方向制御のための低コスト3Dプリントサーボジンバルの設計と試験
Design and Testing of a Low-Cost 3D-Printed Servo Gimbal for Thrust Vector Control in Model Rockets
学生やホビイスト向けに、3Dプリントとサーボで駆動する低コスト2軸ジンバルを設計・試作し、±5度以内の安定した推力方向制御と平均44.5msの応答時間を実証した。
詳しい要約
1. どんなもの?
2. 先行研究と比べてどこがすごい?
3. 技術・手法の肝は?
4. どうやって有効だと検証した?
5. 議論はある?
6. 次に読むべき論文は?
※ AIが要旨から生成した要約です。正確性は原文をご確認ください。
著者: Ekansh Singh
分類: eess.SY, cs.RO, cs.SY
原文アブストラクト
Thrust vector control (TVC) is a key mechanism for stabilizing rockets during flight, yet conventional implementations remain costly and technically inaccessible to students and hobbyists. This paper presents the design, fabrication, and testing of a low-cost, 3D-printed, servo-driven two-dimensional gimbal developed for model rocket applications. The gimbal underwent more than 60 CAD iterations, with servo selection guided by torque, response time, and stability requirements. A high-speed camera and Fusion 360 parameter simulations were used to emulate dynamic instability, enabling evaluation of angular deflection, servo responsiveness, and structural durability. The results demonstrated stable actuation within plus or minus 5 degrees, with response times on the average order of 44.5 ms, while limitations included servo fatigue and pin-joint stress under extended loading. The project highlights the feasibility of student-accessible thrust vector control systems and their potential as a reproducible platform for STEM education and experimental aerospace research.
