アクチュエータを考慮した冗長ロボットの関節限界許容性を持つ逆運動学
Actuator-Aware Inverse Kinematics with Joint-Limit Admissibility for Torque-Controlled Redundant Robots
トルク制御の冗長ロボットに対し、関節限界を考慮しつつ下流のトルク制御器と整合する逆運動学を凸二次計画問題として定式化し、実験で有効性を示した。
詳しい要約
1. どんなもの?
2. 先行研究と比べてどこがすごい?
3. 技術・手法の肝は?
4. どうやって有効だと検証した?
5. 議論はある?
6. 次に読むべき論文は?
※ AIが要旨から生成した要約です。正確性は原文をご確認ください。
著者: Mohammad Dastranj, Mahdi Hejrati, Jouni Mattila
分類: cs.RO
原文アブストラクト
This paper proposes actuator-aware inverse kinematics for torque-controlled redundant robots under joint-limit constraints. In the considered architecture, the inverse-kinematic output is not merely a purely kinematic joint-velocity command; it is the required joint velocity supplied to a downstream torque-level controller. Therefore, a small commanded task residual may not necessarily improve realized motion. The proposed method formulates a convex quadratic programming problem whose decision variable is the joint-level required velocity. Control barrier function style bounds impose reference-level joint-limit admissibility, while the task equation is handled through a penalized slack variable. Redundancy is resolved using a controller-compatibility objective that accounts for previous-command consistency and actuator torque-capacity weighting. The method is independent of the particular torque-level controller and can serve as an intermediate IK layer between an endpoint trajectory and a redundant robot controller. Experiments on a virtual-decomposition-controlled seven-degree-of-freedom upper-limb exoskeleton compare the method with standard inverse-kinematic baselines and a constrained task-preserving quadratic programming baseline. The results indicate lower limit-pushing commands, bounded admissible required velocities, and improved realized task behavior in the tested trajectory, without modifying the downstream controller.
