最小二乗法と力学モデリングによる義足ソケット内の法線・せん断界面圧力推定の試み
Towards Estimating Normal and Shear Interface Pressures in Prosthetic Sockets via Least Squares and Mechanics Modeling
義足ソケットの適合評価のため、スパースな圧力センサ計測と力学モデルを組み合わせ、法線・せん断圧力を推定する手法を検証した。人工残肢を用いたテストベッドで、モデルが全体の力・モーメントと局所の界面荷重を説明できるかを評価している。
詳しい要約
1. どんなもの?
2. 先行研究と比べてどこがすごい?
3. 技術・手法の肝は?
4. どうやって有効だと検証した?
5. 議論はある?
6. 次に読むべき論文は?
※ AIが要旨から生成した要約です。正確性は原文をご確認ください。
著者: Axel González Cornejo, Tianhao Yu, Chi Hwan Lee, Edgar Bolívar-Nieto
分類: cs.RO
原文アブストラクト
Prosthetic socket fitting remains largely manual and iterative, and objective fit metrics are still limited. Part of the challenge is the lack of long-term real-life pressure data at the residual limb--socket interface. Traditional pressure sensors are prone to drift over time, and capture only normal pressures at sparse locations within the socket, missing a critical component for biomechanical analysis: shear. Although some sensors can report both normal and shear interface stresses, these components are often difficult to decouple because of measurement crosstalk. One potential path forward is to develop models that can augment available measurements. This work introduces a testbed to evaluate model performance under sparse pressure sensing using two complementary validation signals: (i) the global wrench (\ie, total forces and moments expressed in an orthonormal frame) transmitted through the socket, by an artificial residual-limb, and (ii) local interface loads (\ie, decoupled normal and shear pressure components in a right-hand-rule orthogonal frame that lives in each instrumented location) measured by sparse sensing clusters, each composed of four capacitance-sensing channels. Rather than presenting full-field pressure estimates, the focus is on an analysis sequence that quantifies how well candidate mechanical models explain both global and local measurements under controlled conditions. A quasi-static spring--mass contact model is evaluated, and its parameters are identified via a two-stage convex least-squares problem. Validation under static loading shows that estimating constant bias terms reduces steady offsets in the wrench channels and improves agreement with local measurements. A Pareto-front sensitivity analysis further illustrates how the trade-off between global and local objectives changes when bias terms are included.
